KitchenAid KUCS02FRPA Use and Care Guide - Page 10

3. Grasp the drawer on the sides and pull it out the rest of the way. Set the drawer down gently. 4. Vacuum the inside of the cabinet. Liquid spills or wet trash should be cleaned up by hand, or by using a vacuum designed to pick up liquids. Cleaning the Ram NOTE: You may want to wear protective gloves since there may be bits of glass on the ram cover. 1. Wipe glass particles off of the ram cover with a cloth or paper towels. 2. Remove foods with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. 5. Wash the inside of the cabinet with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. 6. To replace the drawer, grasp it by the sides and insert the rollers onto the tracks. 7. Lift the front of the drawer and push it in fully past the stops. Cleaning Before a Vacation If you will be away for more than a couple of days, remove the compactor bag. Remove the Key-Knob (or Key-Switch) and store it out of children's reach. TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. Trash is not compacting ■ Is the drawer less than half-full? Drawer must be more than half full before trash is compacted. Your compactor won't operate ■ Is the power supply cord unplugged? Plug into a grounded 3 prong outlet. ■ Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■ Is the drawer completely closed? Close the drawer firmly and start the compactor again. ■ Is the Key-Knob turned all the way to START? Turn the Key-Knob (Key-Switch) fully to START and release (on some models). See "Starting Your Compactor." ■ Did you press ON before pressing START? Press ON before pressing START (on some models). See "Starting Your Compactor." The drawer won't open ■ Is the ram all the way up? Drawer will open only when ram is fully raised. To raise the ram on models with a Key-Knob (or KeySwitch): Turn the Key-Knob (Key-Switch) to START and release. See "Starting Your Compactor." To raise the ram on models with push button controls: Press OFF, and then press ON. See "Starting Your Compactor." ■ Is the Solid Cycle engaged? Drawer remains LOCKED until you reset by lifting the foot pedal up. There is not enough compaction or force ■ Do you use the compacting cycle frequently enough? Compacting works best when only a few items are loaded. Bottles don't break ■ How often do you notice this? Bottles will not break every time. The thickness of the bottle's glass and the content of the trash load below it may keep the bottle from breaking. 10