KitchenAid KURG24RWBS Use & Care Guide - Page 5

■ Dispose of/recycle all packaging materials. When Moving Your Wine Cellar: Your wine cellar is heavy. When moving the wine cellar for cleaning or service, be sure to protect the floor. Always pull the wine cellar straight out when moving it. Do not wiggle or "walk" the wine cellar when trying to move it, as floor damage could occur. 3. Turn the leveling legs to the right to lower the wine cellar or turn the leveling legs to the left to raise it. It may take several turns of the leveling legs to adjust the tilt of the wine cellar. NOTE: Having someone push against the top of the wine cellar takes some weight off the leveling legs. This makes it easier to adjust the leveling legs. Clean Before Using After you remove all of the packaging materials, clean the inside of your wine cellar before using it. See the cleaning instructions in "Wine Cellar Care." Door Closing Door Closing Your wine cellar has four leveling legs. If your wine cellar seems unsteady or you want the door to close more easily, adjust the wine cellar's tilt using the instructions below. WARNING 4. Open the door and check to make sure that it closes as easily as you like. If not, tilt the wine cellar slightly more to the rear by turning both front leveling screws to the right. It may take several more turns, and you should turn both leveling legs the same amount. Base Grille Remove the Base Grille 1. Open the wine cellar door. 2. Using a Phillips screwdriver, remove the two screws. Push both tabs in toward the center to release the base grille from the wine cellar. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. WARNING Excessive Weight Hazard Use two or more people to move and install wine cellar. Failure to do so can result in back or other injury. 2. Move the wine cellar into its final location. A B A A. Tabs B. Screws 3. Remove the base grille. Replace the Base Grille 1. Open the wine cellar door. 2. Position the base grille so that both tabs align and the base grille snaps into place. Replace the two screws. Tighten the screws. 5