Kodak I260 User Guide - Page 44
Installing the imprinter, Removing the circuit board cover, cover
UPC - 041771844417
View all Kodak I260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Installing the imprinter Removing the circuit board cover 1. Make sure that the scanner is powered down and there are no documents in the feeder area. 2. Disconnect the power cord from the back of the scanner. 3. Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on the back of the scanner. 4. Lift up the scanner door release to unlatch the scanner door. 5. Pull up to open the scanner door. 6. Remove the output tray. 7. Lift up the scanner door release again and open the scanner door past the circuit board cover. Circuit board cover 8. Use a Phillips-head screwdriver to remove the two screws (one front, one back) that hold the circuit board cover in place. C-2 A-61167 April 2005
C-2
A-61167
April 2005
Installing the imprinter
Removing the circuit board
cover
1.
Make sure that the scanner is powered down and there are no documents
in the feeder area.
2.
Disconnect the power cord from the back of the scanner.
3.
Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on
the back of the scanner.
4.
Lift up the scanner door release to unlatch the scanner door.
5.
Pull up to open the scanner door.
6.
Remove the output tray.
7.
Lift up the scanner door release again and open the scanner door past the
circuit board cover.
8.
Use a Phillips-head screwdriver to remove the two screws (one front, one
back) that hold the circuit board cover in place.
Circuit board cover