Konica Minolta bizhub PRESS 1250 Watkiss PowerSquare 224 Safety Manual - Page 5

CHAPTER 1 (UK) User Safety Information Instructions for safe use This product is designed with safety as an important feature and according to international safety standards. Read and follow these safety rules. Safety Rules • Do only maintenance procedures that are included in the User Manual. • Do not remove screws, hardware or covers, unless you are told to in the User Manual. • Do not remove covers before the machine is disconnected from the main power supply. Refer to the User Manual for the correct procedure. • Do not change fuses before the machine is disconnected from the main power supply. Refer to the User Manual for the correct procedure. • Do not modify the machine. A modified machine is not safe to operate. The product warranty is cancelled if you modify the machine. • Do not change or adjust the safety interlock switches fitted to the machine. • Do not use the machine if the machine makes unusual noises. Turn off the machine. Disconnect the machine from the main power supply. Call your Watkiss service engineer. Installation • Only an approved Watkiss service engineer must install the machine. • Only connect the machine to a mains power supply of the correct voltage with a good earth-connection. The correct machine-voltage is shown on the label at the mains power supply input on the rear of the machine. If the machine is connected to the wrong supply, the warranty is cancelled. • Make sure there is enough work area around the machine. Refer to the Site Requirements document for the machine. • Install the machine on a level floor. • Use caution when you move the machine. The machine is heavy. Watkiss PowerSquare™ 200 Series User Safety Manual 1