Kyocera C270N Installation Guide - Page 1
Kyocera C270N - EcoPro EP Color Laser Printer Manual
UPC - 632983011935
View all Kyocera C270N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
EP C170N/EP C220N/EP C270N Installation Guide Unpacking Unpack the printer and components. Remove the filler. Important! Kyocera Mita assumes no liability for any damage caused by an improper installation of the printer. Check Parts and Components When carrying the printer, always hold the right and left sides as shown. Rear Filler Install the Toner Containers and Waste Toner Box Close the paper transfer unit tightly. Open the top cover and remove the packing item. 1. Printer 2. Documentation and software • Installation Guide (this sheet) • Other Printed Matters • CD-ROM 3. Magenta Toner Container 4. Cyan Toner Container 5. Yellow Toner Container 6. Black Toner Container 7. Waste Toner Boxes (one is spare) 8. Power cord Hold the toner container with the markings (caution notes, etc.) facing downward and shake it 5 or 6 times as shown. Place the new toner container in the printer with the markings facing upward. Packing Item This example shows installing the black toner container. Toner Supply Opening Do not push the center of the container or touch the toner supply opening during this procedure. Note Ensure the toner container is in the correct location for that color. Push down on the container until it clicks firmly into place. Apply light pressure to the container and push the blue lock lever back towards the locked symbol as far as it will go. Lock Lever Magenta (M) Cyan (C) Yellow (Y) Black (K) Open the left cover. Follow the procedure above to install the other color toner containers. Open the cap of the waste toner box. Position the bottom of the waste toner box in the receptacle and push the box down until it snaps firmly into place. Close the top cover. Close the left cover. Cap Make Connections Connect the printer to your computer. (The connecting cable is sold separately.) Parallel Interface (EP C270N only) USB Interface Network Interface (Ethernet) Remove the cap, when using the network interface. Connect the provided power cord to the connector. Turn on ( | ) the power switch located on the left side of the printer. Power Cord Connector Continued on the Reverse page Basic installation is now complete. Before using the printer, set the color registration. Refer to "Setting the Color Registration" procedure on the reverse page.