Kyocera ECOSYS FS-2020D KYOmulticode 1.0- PCL Barcode Flash 3.0 Quick Installa - Page 8
Min. 16 MB RAM recommended, The following minimum requirements for the device used should be met so
View all Kyocera ECOSYS FS-2020D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
An up-to-date compatibility list is available in the service area of www.kyoceramita.eu Note For some of the older supported devices, in certain cases it might be necessary to make a firmware update. Note Please note that KM series multifunction devices have to be fitted with a printer board. Note PCL Barcode Flash assumes that you have a free CF card slot in your printer or multifunction device Note The following minimum requirements for the device used should be met so that PCL Barcode Flash can run without complications: • Firmware as of April 2001 or newer • Min. 16 MB RAM recommended 8
An up-to-date compatibility list is available in the service area of
www.kyoceramita.eu
Note
For some of the older supported devices, in certain cases it might be
necessary to make a firmware update.
Note
Please note that KM series multifunction devices have to be fitted with a
printer board.
Note
PCL Barcode Flash assumes that you have a free CF card slot in your printer
or multifunction device
Note
The following minimum requirements for the device used should be met so
that PCL Barcode Flash can run without complications:
•
Firmware as of April 2001 or newer
•
Min. 16 MB RAM recommended
8