Kyocera FS-1128MFP FS-1028MFP/1128MFP Operation Guide Rev-3 - Page 82

Preparation before Use Loading Originals Follow the steps below to load originals for copying, sending or storing. Placing Originals on the Platen You may place books or magazines on the platen in addition to ordinary sheet originals. 1 Open the original cover. NOTE: If the optional document processor (DP-110) is installed, open the document processor. Before opening the document processor, be sure that there are no originals left on the original table or on the original eject table. Originals left on the original table or on the original eject table may fall off when the document processor is opened. Keep the document processor open if the original is 25 mm or thicker. 2 Place the original. Put the scanning side facedown and align it flush against the original size indicator plates with the back left corner as the reference point. 2-42 3 Close the original cover. IMPORTANT: Do not push the original cover forcefully when you close it. Excessive pressure may crack the platen glass. Do not close the document processor when the original is 25 mm or thicker. The connector of the document processor will be removed form the machine. NOTE: Shadows may be produced around the edges and in the middle of open-faced originals. CAUTION: Do not leave the document processor open as there is a danger of personal injury. OPERATION GUIDE