Kyocera FS 8000C FS-8000C Installation Instructions Rev-1 - Page 1

FS-8000C Series Printers Installation Guide Unpacking 1 Unpacking the Printer Yes! No! Warning: To avoid injury, the printer must be lifted and carried by two persons or more. Important! Installation should be performed only by a qualified service personnel. Kyocera Mita assumes no liability for any damage caused by an improper installation of the printer. Checking Parts and Components 2 8 14 2 12 9 1 6 10 15 7 16 18 17 3 5 4 11 13 13 Unpacking the Paper Feeder PF-30A for FS-8000C PD-30 for FS-8000CD 1 Documents Installation Guide (This sheet) Quick Reference Guide CD-ROM 2 Cyan Developer 3 Magenta Developer 4 Yellow Developer 5 Black Developer 6 Cyan Toner Container 7 Magenta Toner Container 8 Yellow Toner Container 9 Black Toner Container 10 Secondary Transfer Unit 11 Fuser Unit 12 Oil Unit 13 Waste Toner Bottles 14 Power Cord 15 Filter Duct 16 Quick Reference Guide Holder 17 Jig (Used in step 9) 18 Screws (Used in steps 9 and 16) The following setup assumes three paper feeders to be installed with the printer (including the one supplied as a standard accessory), which requires a CA-31B caster kit to be installed on the bottom of the bottom paper feeder. If the extra paper feeders are not installed, the CA-31 casters may be used. See the Operation Guide for more details. Placing the Printer 3 Attaching the Caster kit (purchased separately): Remove each one screw to remove four feet. 4 Stand the paper feeder on its back side. Install the caster kit onto the bottom of the 5 paper feeder. Be sure to face the longer end towards the front of the feeder. 6 Place the paper feeder in a proper location. Lock the stopper for each caster. Turn the bolts to adjust height. Using a topple-resistant bracket (supplied with the CA-31B caster kit), stack and joint the bottom and middle paper feeder. 7 Using another topple-resistant bracket, stack and joint the middle and top paper feeder. 8 9 Place the printer over the paper feeders (by at least two persons). Join the printer and topmost paper feeder with the jig provided by using one screw. 10 Install the filter duct and the quick reference guide holder. Peel the protective tape off when attaching the holder. Quick Reference Guide Holder Filter Duct Installing the Fuser Unit, Oil Unit, Secondary Transfer Unit, and Waste Toner Bottle 11 Open the front cover. 12 Pull out thoroughly the paper feed unit. 13 14 Unscrew the screw. Remove the lock pin and release the (green-colored) lock lever. Pull out the primary transfer unit until it stops. Screw Lock Pin While pushing the gray lever, pull out the primary transfer unit. Make sure not to scratch the roller. Gray Lever Lock Lever Continued on the Reverse Page