LG DLG7188RM Owners Manual - Page 17
est wmln er - red
View all LG DLG7188RM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Important : Grounding through the neutral conductor is prohibited tbr (1) new branch-circuit installations, (2) mobile homes, and (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. Prepare minimum 5ft( 1.52m) of length in order for dryer to be replaced. First, strip 3 _/2inches (8.9cm) of outer sheath from end and strip 1 inch of insulation from each conductor. ,¢ • If your local codes or ordinances do not allow the use of a 3 wire connection, or you are installing your dryer in a mobile home, you must use a 4wire connection. { 4-wire receptacle NEMA type 14-30R) _4-pront plua _ S Ptadet_rgic_s his with Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly. _NeutrN Prong nt plug _ 3/4 inp.pr(o1v.9ed cms) train relief _L NeeuG[t21Updo p rg n g Ring terminals 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Make sure that the strain relief screw is tightened and be sure that all terminal block nuts are on tight and power cord is in right position. Ce est wmln er) __ Neutralgrounding _2_ I_]:_ _ wiretwhite) ,_o_ _"_- _" _\ _ _L__ Neutral grounding wire(white) Strain relief I/_r- External ground connector Center terminal block screw(siNer) -- Neutral grounding wire(white) Neutral wire (white or center wire) Strain relief Green wire of power cord External ground connector 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Connect ground wire(green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened. and be sure that all terminal block nuts are on tight and power cord is in right position. 17