LG DLG7188RM Owners Manual - Page 7

gas connections - review

Page 7 highlights

The following instructions will help guide you through the initial steps of setting up your dryer for use. Please note that every section of this manual provides important information regarding the preparation and use of your dryer, and it is important that you review this entire manual before proceeding with any installation or use. More detailed instructions concerning electrical connections, gas connections, and exhaust requirements are provided in other parts of this manual. Choose a location with a solid floor for your dryer. Place the dryer at least eighteen inches above the floor for a garage installation. After placing the dryer in the desired location, please make sure that it has the required clearances shown below. If you are installing your dryer in a manufactured or mobile home, please refer to STEP 9 below for additional instructions. Certain minimum clearances are required _he sides of the unit as shown below. Those required minimum clearances are set forth in the picture below. Please keep the following instructions in mind when installing in a closet or recessed area: • Consider allowing additional clearance for hlstalladon and servicing. • Wall, door and floor molding may force additional clearances. • An additional inch of clearance is recommended to minimize noise transfer. • Consider space needed for companion appliances. • For closet installations, the picture below shows the minhnum required ventilation openings for the door. A louvered door with comparable ventilation openings is also acceptable. 3Bt (7.6 cm) 48 t_2. (310 cm 2) ventilation hole * Most installations require a minimum 5 1/2 in. (14 cm) clearance behind the dryer for the exhaust vent with elbow. Leveling legs should be secured. All four legs are stably placed on the solid and even fleer. if dryer is not levN, laundry may not tumble properly and sensor will not detect the accurate humidity information. When leveling, please be cautious not to injure your lingers and toes. If you install the dryer on the optional pedstal. it is nessary to level with the pedestal levNing legs. 24*'2 (155 cm_).. (7.6 cm) ventilation hole "i _ (2.54cm) 29.9" (76.1 cm) (2.54cm) 0" _ (0 cm) 27" _1_0" (68.6 cm) (0 cm) 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

The following
instructions
will help guide you through the initial steps of setting up your dryer for use.
Please note that every section of this manual provides important
information regarding the preparation
and
use of your dryer, and it is important
that you review this entire manual before proceeding with any
installation or use. More detailed instructions concerning
electrical connections,
gas connections,
and
exhaust requirements
are provided in other parts of this manual.
Choose
a location
with
a solid
floor
for your dryer.
Place
the dryer
at least
eighteen
inches
above
the
floor
for a garage
installation.
After
placing
the
dryer
in the
desired
location,
please
make
sure
that
it has the
required
clearances
shown
below.
If you
are installing
your
dryer
in a manufactured
or
mobile
home,
please
refer
to STEP
9 below
for
additional
instructions.
Certain
minimum
clearances
are
required
_he
sides
of
the unit
as
shown
below.
Those
required
minimum
clearances
are set forth in the picture
below. Please
keep the
following
instructions
in mind when installing
in a
closet or recessed
area:
• Consider
allowing
additional
clearance
for
hlstalladon
and servicing.
• Wall, door and floor molding
may force additional
clearances.
• An additional
inch of clearance
is recommended
to
minimize
noise transfer.
• Consider
space
needed
for companion
appliances.
For
closet
installations,
the picture
below
shows the
minhnum
required
ventilation
openings
for the door.
A louvered
door with comparable
ventilation
openings
is also acceptable.
* Most
installations
require
a minimum
5
1/2
in.
(14 cm)
clearance
behind
the dryer
for the
exhaust
vent
with elbow.
Leveling legs
should be
secured.
All
four
legs are stably placed on
the
solid
and
even
fleer.
if dryer is
not
levN, laundry
may
not
tumble
properly
and
sensor will
not
detect
the
accurate
humidity information.
When leveling, please
be
cautious
not to
injure
your
lingers
and toes.
If you install
the
dryer
on the
optional pedstal.
it is
nessary to
level with
the
pedestal levNing
legs.
3Bt
..........................................
(7.6cm)
48
t_2.
(310 cm 2)
24*'2
(155 cm_)
..
(7.6cm)
<Closet
door>
ventilation
hole
ventilation
hole
"i _
29.9"
(2.54cm)
(76.1
cm)
(2.54cm)
<Closet-Side
view>
0" _
27"
_1_0"
(0 cm)
(68.6 cm)
(0 cm)
<Closet-Front
view>
7