LG LBC22520TT Owner's Manual (English) - Page 17

REFRIGERATOR INSTALLATION AFTER COMPLETING THE JOB Make sure that the four corners of the door gasket are not folded over. To ensure a good seal, apply a small amount of silicon grease on the gasket. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling screws. This makes it easier to adjust the screws. 3. Open both doors again and check to make sure that they close easily. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws clockwise. It may take several more turns, and you should turn both leveling screws the same amount. 4. Check, using a level. 5. Replace the base grille. DOOR CLOSING AND ALIGNMENT Door Closing Your refrigerator has two front leveling screws one on the right and one on the left. If your refrigerator seems unsteady or you want the doors to close easier, adjust the refrigerator tilt using the instructions below: 1. Plug the refrigerator power cord into a 3-prong grounded outlet. Move the refrigerator into its final position. 2. Use a screwdriver to adjust the leveling screws. Turn the leveling screw clockwise to raise that side of the refrigerator or counterclockwise to lower it. It may take several turns of the leveling screw to adjust the tilt of the refrigerator. Door Alignment If the space between your doors is uneven, follow the instructions below to align the doors: 1. Pry off the top hinge cover. 2. Loosen the top hinge screws using a 10 mm socket or wrench. 3. Have someone hold the door in place or put a spacer between the doors while you tighten the top hinge screws. 4. Replace the top hinge cover. 17