LG WT5101HV Owner's Manual - Page 12
Connect To The Power Supply, Connecting The Drain Line, Leveling The Washer
View all LG WT5101HV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALLATION INSTRUCTIONS CONNECTING THE drain LINE (cont.) Firmly insert the free end of the drain hose into the drain opening of your home. Make sure the soft rubber end is completely inside the drain opening. • If the water valves and drain are built into the wall, fasten the drain hose to one of the water hoses with the cable tie (ribbed side on inside). • If your drain is a standpipe, fasten the drain hose to the standpipe with the cable tie provided. NOTE: • Total height of the hose end should be approximately 35 ~ 47" (0.9 ~ 1.2 m) from the floor. • The drain hose should be inserted no more than 8-12 inches into the standpipe. Cable Tie 39″ 39″ (99 cm) (99 cm) Cable Tie LEVELING THE WASHER The washer spins at very high speeds, up to 1,100 RPM. NOTE: Adjust the leveling feet only as far as necessary to level the washer. Extending the leveling feet more than necessary can cause the washer to vibrate. • All four leveling feet must rest solidly on the floor. Rock the washer gently from corner to corner to make sure that the washer does not rock. NOTE: Before installing the washer, make sure the floor is clean, dry and free of dust, dirt, water and oils so the washer feet can not slide easily. Leveling feet that can move or side on the floor can contribute to excess vibration and noise due to poor contact with the floor. 1 Position the washer in the final location, taking special care to not pinch, strain, or crush the water and drain lines. Place a level across the top of the washer. 12 Raise Lower 2 A djust the 2 front leveling feet. Turn clockwise to raise the washer or counterclockwise to lower it. 3 To make sure that the washer is properly level, open the lid and look from above to see if it is same as shown above. If you have a level, check your washer with the level. • To check if the washer is level side to side, close the lid and place a level at the back of the lid. • To check if the washer is level front to back, place a level at the side of the washer on the edge where the cabinet side meets the top cover. side to side front to back Lower Raise If the washer is not level, adjust the front leveling feet. Turn clockwise to raise, counterclockwise to lower. CONNECT TO THE POWER SUPPLY The washer should be plugged into a 120V AC, 60Hz grounded 3-prong outlet. Plug in the washer.