LG WT7060CW Owners Manual - Page 32
Start/Pause
View all LG WT7060CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
32 TROUBLESHOOTING Problem Possible Cause Lid (Door) is not closed properly. Lid (Door) lock switch error. Foreign objects such as coins, pins, clips, etc., caught between the wash plate and the inner basket. Solutions Close the lid (door) and press Start/Pause button. After starting a cycle, it may take a few moments before the tub begins to turn or spin. The washer will not spin unless the lid (door) is locked. If the error persists once the lid (door) is closed and the Start/Pause button is pressed, call for service. Make sure that the lid (door) is closed properly and press the Start/Pause button. The washer will not operate unless the lid (door) is locked. Make sure that nothing is caught under the lid (door), including shipping material or clothing. Make sure that the latch mechanism is fully retracted. If the lid (door) is closed and the lid (door) lock error message is displayed, call for service. Turn the washer off then on again. Press the Spin button without selecting a cycle to drain and spin the load. When the Spin cycle is complete, empty the tub and find and remove any objects caught in the wash plate. Always check pockets, etc., before washing to prevent error codes or damage to the washer or clothing. It is time to run the Tub Clean cycle. Run the Tub Clean cycle. The washer has detected an out of balance load. Control error. Water level is too high due to a faulty water valve. The water level sensor is not working correctly. A motor error has occurred. Clutch error If the washer detects a load that is too far out of balance to spin, it will display this code while it is attempting to rebalance the load. The washer will add water and try to redistribute the load automatically. This display is for your information only, and no action is required. As a result, the cycle will take longer than initially estimated. Unplug the washer and wait 60 seconds. Reconnect power and try again. If the error reappears, call for service. Close the water faucets, unplug the washer, and call for service. Close the water faucets, unplug the washer, and call for service. Allow the washer to stand for 30 minutes and then restart the cycle. If the LE error code persists, call for service. Mechanical failure Unplug the washer and call for service.