Lenovo ThinkCentre A58 User Manual - Page 113

10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and slide the hard disk drive cage into the chassis. 11. Connect the signal cable and the power cable to the rear of the new hard disk drive. 12. Press down on the metal latch 2 and pivot the drive cage into place, and then slide it forward until it snaps into position. Note: There are two arrows, one on the upper drive cage and one on the hard disk drive cage. The arrows are aligned when the hard disk drive is in the proper position. Figure 23. Installing the primary hard disk drive with the hard disk drive cage What to do next: v To work with another piece of hardware, go to the appropriate section. v To complete the replacement, go to "Completing the FRU replacement" on page 120. Replacing the secondary hard disk drive Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support This section provides instructions on how to replace the secondary hard disk drive. Chapter 8. Replacing FRUs - Tamdhu 107