Lexmark C920 SCS/TNe Emulation User’s Guide - Page 162
Lst Rsp:8902:Device not available, Lst Rsp:8920:Object partially damaged
View all Lexmark C920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Connect # Status: Last response messages Lst Rsp:8902:Device not available Lst Rsp:8903:Device not valid for session Lst Rsp:8906:Session initiation failed Lst Rsp:8907:Session failure Lst Rsp:8910:Controller not valid Lst Rsp:8916:No matching device found Lst Rsp:8917:Not authorized to object Lst Rsp:8918:Job canceled Lst Rsp:8920:Object partially damaged Lst Rsp:8921:Communication error Lst Rsp:8922:Negative response received Lst Rsp:8923:Start-up record incorrectly Lst Rsp:8925:Creation of device failed Lst Rsp:8928:Change of device failed Lst Rsp:8929:Vary on or vary off failed Lst Rsp:8930:Message queue does not exist Comments The requested device is not available on the system. It has probably been assigned to another Telnet session. Check with system operator. Check with system operator. Check with system operator. Check with system operator. An exisisting device configuration was not found and the autoconfiguration of virtual devices did not allow any new device descriptions to be created. Check with system operator. Check with system operator. The device description object on the host has been damaged. Check with system operator. The SCS/TNe Emulation was not able to establish a Telnet session. It will try again automatically. Check with system operator. The SCS/TNe Emulation device was not created succesfully. Check with system operator. Check with system operator. Check with system operator. Operations - TN5250E SETUP: CONNECTION # > Connect # Status 162