Lexmark T520 Service Manual - Page 33
SRAM Failure, ASIC Failure
UPC - 734646620000
View all Lexmark T520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4520-xxx Error Code 940 Service LV Power Supply 941 Controller Code CRC 941 Controller Font CRC 943 Controller Font Version 944 Controller Board Failure 945 Controller Board Failure ASIC Failure 946 Controller Board Failure SRAM Failure 947 PQET Error 948 PEL Clock Error 949 Delay Line Calibration Failure 953 NVRAM Failure 954 NVRAM Failure Action The low voltage power supply zero crossover test failed. • Check the LVPS for correct installation. Ensure that the connector on the LVPS assembly is firmly seated with the connector on the interconnect card connector. This error may also be caused by a noisy AC input power source. • Be sure the correct LVPS has been installed. • If all the above are correct, replace the LVPS assembly. A 941 error can be created by a defective code overlay card, a code upgrade, a defective IPDS or a PRESCRIBE card. These should be checked before replacing the controller board. Replace the controller board. Indicates that the controller code and FONT ROM are incompatible. Replace the controller board. Replace the controller board. Replace the controller board. Replace the engine board. Indicates the PEL clock check failed. Replace the engine board. Indicates a delay line calibration failure. Replace the engine board. Indicates the NVRAM chip on the engine board has failed. Replace the engine board. Indicates the NVRAM experienced a CRC failure. Replace the engine board. Diagnostic Information 2-5