Lexmark T644 Quick Reference

Lexmark™ T64x

Quick Reference

Loading paper and

specialty media

Loading standard trays and

optional trays

1

Remove the tray from the printer, and place it on

a flat, level surface.

Note:

Do not remove a tray when a job is

printing or when the control panel

green indicator light is blinking.

Doing so may cause a jam.

2

Squeeze the side guide tab, and slide the guide

to the outer edge of the tray.

3

Squeeze the rear guide tab, and slide the guide

to the correct position for the size media you are

loading.

4

Flex the sheets back and forth to loosen them,

then fan them. Do not fold or crease the print

media. Straighten the edges on a level surface.

5

Place the print media in the tray:

•

Print side facedown for

simplex

(single-sided)

printing

•

Print side faceup for duplex printing

6

Squeeze the side guide tab, and slide the guide

toward the inside of the tray until it lightly rests

against the edge of the media.

7

Insert the tray into the printer.

Loading the 2000-sheet drawer

1

Open the loading door. If the elevator tray is not

already in the lowered position, push the

elevator button to lower the tray.

2

Flex the sheets back and forth to loosen them,

then fan them. Do not fold or crease the print

media. Straighten the edges on a level surface.

3

Slightly bend the stack of print media as shown,

and place it on the elevator tray with the

preferred print side facing down.

4

Carefully align each stack as you load it to

ensure a smooth edge where the stacks meet.

Do not load print media above the load line.

5

Close the loading door.

Loading the multipurpose feeder

1

Push the release latch, and lower the

multipurpose feeder.

2

Pull the tray extension out.

Simplex

(single

sided)

Duplex

Lexmark T644 Quick Reference

Lexmark T644 Manual

Lexmark T644 manual content summary: