Lexmark W812 Technical Reference - Page 110
Common Variables for Both Printer Languages
View all Lexmark W812 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
3-12 PJL Common Variables for Both Printer Languages Note: The word common applies to those variables common to both your printer and the Hewlett-Packard Company's LaserJet printers. The following common variables are supported for both PCL emulation and PostScript emulation, unless otherwise noted. Therefore, the [command modifier:value] parameter should not be specified. To determine which variables your printer supports, see Table B-1: "Common Variables for Both Printer Languages" on page B-1. Table 3-3: Common Variables for Both Printer Languages Variable Function Selections Factory Default AUTOCONT Auto Continue 0, 5 to 255, OFF, ON 0 (DEFAULT only) A value of 0 or OFF indicates Auto Continue is disabled. A value of ON indicates Auto Continue is set to 30. INQUIRE or DINQUIRE on the Auto Continue variable returns a numeric value. Note: If a value greater than 255 is specified by a SET or DEFAULT command, the value is changed to 255. BINDING Duplex Bind LONGEDGE, SHORTEDGE LONGEDGE BITSPERPIXEL Image Enhancement Technology and Image Enhancement Technology Type 1, 2, 4, Auto 1 A value of 1 indicates the Image Enhancement Technology setting is set to Off. A value of 2 or 4 indicates the Image Enhancement Technology setting is set to On. INQUIRE or DINQUIRE returns the value of Image Enhancement Technology as follows: • If Image Enhancement Technology is set to Off, 1 is returned. • If Image Enhancement Technology is set to On, 2 or 4 is returned depending on the Image Enhancement Technology Type setting. If Image Enhancement Technology Type is set to On, the numerical value of BITSPERPIXEL is returned. If Image Enhancement Technology Type is set to Auto, a value of 2 or 4 is returned depending on the amount of total memory installed. CLEARABLEWARNINGS Auto Continue JOB, ON ON (READ only) from operator panel non-fatal If Auto Continue is set to On, JOB is returned. warning messages If Auto Continue is set to Off, ON is returned.