LiftMaster 61LM Owners Manual - Page 281

® Models CLLA1, CLLA1C Security✚ Plug-In LightWCAonRtrNoIlNG Modèles N° CLLA1, CLLA1C Security✚ Commande d'eclairage enfichable Modelos CLLA1, CLLA1C Security✚ Control de luz dCeAeUncThIOufNe Light Control Actuator Commutateur de commande d'éclairage Actuador de control de luz Antenna Antenne Antena Learn Button Bouton LEARN Botón "APRENDER" (Learn) Learn Indicator Light Voyant indicateur d'apprentissage Luz indicadora de aprendizaje OWNER'S INSTRUCTIONS The Plug-In Light Control is designed to operate lights according to the rating chart shown. Please read the instructions and power limitations carefully to ensure proper use and maximum safety. NOT recommended for use with toasters, coffee pots, florescent or halogen lighting systems. This Light Control can be operated by Models 700, 800 and 900 Chamberlain Series portable remote controls and Keyless Entries. In addition it is also compatible with Clicker Models CLT1 and CLK1. Please refer to the Clicker owner's manual included with these products for programming instructions. • For Clicker CLT1: See the "Chamberlain" brand section, Type A programming. • For Clicker CLK1: See Section 3, systems with a Smart-Learn button. The Plug-In Light Control receiver needs to learn the remote control code. Follow the instructions below: • Plug the light control into a 120Vac polarized outlet. The plug contacts are designed for polarized outlets only. • Press and release the "learn" button on the Plug-In Light Control with a pen or pencil tip. The learn indicator light will glow steadily for 30 seconds. • Within 30 seconds, press and hold the button on the hand-held remote. Select a push button • Release the remote control push button. Code setting is now complete. The remote control push button must be held down until the receiver indicator light flashes for the light control to learn the remote control's code. WARNING To prevent possible SERIOUS INJURY or DEATH from electrocution or fire, the light control is ONLY for indoor use. CAUTION AVERTISSEMENT Pour éviter les risques de BLESSURE GRAVE ou de MORT causés par l'électrocution ou l'incendie, la commande d'éclairage doit être ATTENTION utilisée UNIQUEMENT pour l'intérieur. ADVERTENCIA A AVERTISSEMENT Para prevenir LESIONES GRAVES O LA MUERTE posibles de electrocución o incendio, el control de luz es para uso interior SOLAMENTE. ATTENTION ENGLISH ERASING CODES If the receiver LEARN button is pressed and held until the yellow indicator light alongside goes out (in about 6 seconds), all memorized codes will be erased. PR OPERATING INSTRUCTIONS If two or more plug-in light controls are installed, they must be located at least 10 feet apart to prevent electronic interference. • First, plug the lamp into a wall outlet and turn it ON. • With the lamp still in the ON position, plug it into polarized outlet on the light control. Plug the Light Control into a 120Vac polarized outlet. The bulb will not light. • TO TEST: Press and release the light control actuator. The light should turn ON. Press the remote control push button. The light should turn OFF. If the remote control does not activate the light, check to be sure: • You are pressing the remote control push button selected to operate the light control. • The remote control battery has power. Refer to the remote control instructions for battery changing information. NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. RATING Resistive Load 10 Amps Motor Load 1/3 HP Incandescent Lamp 600 Watts