LiftMaster 860LM User Guide - Page 2
Programming - parts
View all LiftMaster 860LM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
PROGRAMMING Each channel is compatible with a certain number of remote controls and keypads. Refer to the list below: • CH1: 50 remote controls and 2 keypads • CH2: 20 remote controls and 2 keypads • CH3: 20 remote controls and 2 keypads When the channel has reached full capacity for remote controls, all LEDs will blink 3 times. When the channel has reached full capacity for keypads, all LEDs will blink 4 times. Additional accessories can be programmed, however, the newly programmed accessory will replace the first programmed accessory. NOTE: This receiver will only allow you to program a button on the remote control to one channel at a time. For example, if the button on the remote control is already programmed to channel 1 and then is programmed to channel 3, the button will be erased from channel 1 and will only work on channel 3. CH1 Learn Button CH2 Learn Button CH3 Learn Button PROGRAM A SINGLE BUTTON REMOTE CONTROL 1. Press and release the Learn button for the selected channel on the receiver. The corresponding LED will glow steadily for 30 seconds. 2. Within 30 seconds press and hold the button on the remote control that you wish to program to the receiver. 3. Release the remote control button when the LED on the receiver blinks, then turns off. Programming is complete. Repeat the steps above for each remote control you would like to program. NOTE: The receiver can command the operator to close the door or gate by constant pressure. This feature is only available with a wireless control panel (Model 885LM). To enable this feature, press and hold the push bar until the gate or door moves to the closed position. SPECIFICATIONS Contact Rating 5 Amps 28 Vac or dc Max. Power Rating 9-30V AC or 9-34V DC, 50mA, 60Hz RF Frequency 310, 315, and 390 MHz PROGRAM A 3-BUTTON REMOTE CONTROL AS OPEN, CLOSE, AND STOP 1. Press and release the CH1 Learn button on the receiver. 2. Within 30 seconds press the desired OPEN button on the remote control. 3. Press and release the CH2 Learn button on the receiver. 4. Within 30 seconds press the desired CLOSE button on the remote control. 5. Press and release the CH3 Learn button on the receiver. 6. Within 30 seconds press the desired STOP button on the remote control. NOTE: If a remote control button is not pressed within 30 seconds, the LED next to the selected Learn button will turn OFF. In that case, repeat the programming. TO ERASE THE MEMORY Press and hold the Learn button for the channel you want to erase. Release the button when the corresponding LED turns off; the memory has been erased. NOTE: If your operator does not meet the power specifications you will need a Model 95LM transformer. COMPATIBLE ACCESSORIES Remote Controls Models 811LM, 813LM, 891LM, 893LM, 890MAX, 893MAX, 895MAX, 892LT, 894LT Keypads Models 877LM, 877MAX Wireless Control Panel Model 885LM Antenna Extension Kits 15' Extension Kit Model 86LM 25' Extension Kit Model 86LMT Antenna Only K77-36541 Transformer 95LM NOTICE: To comply with FCC and/or Industry Canada (IC) rules. adjustment or modifications of this receiver are prohibited. THERE ARE NO USER SERVICEABLE PARTS. This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-2806 2