LiftMaster CSW24V CSW24V Manual - Page 35
Maintenance, Maintenance Chart, Batteries, Drive Chain
View all LiftMaster CSW24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
MAINTENANCE MAINTENANCE CHART + BATTERIES + DRIVE CHAIN MAINTENANCE CHART Disconnect all power (AC, solar, battery) to the operator before servicing. The operator's AC Power switch ONLY turns off AC power to the control board and DOES NOT turn off battery power. ALWAYS disconnect the batteries to service the operator. DESCRIPTION TASK CHECK AT LEAST ONCE EVERY MONTH 6 MONTHS 3 YEARS Entrapment Protection Devices Check and test for proper operation X Warning Signs Make sure they are present X Manual Disconnect Check and test for proper operation X Drive Chain and Sprockets Check for excessive slack and lubricate X Belt and Pulley Check for excessive slack, wear or damage X Gate Inspect for wear or damage X Accessories Check all for proper operation X Electrical Inspect all wire connections X Chassis Mounting Bolts Check for tightness X Operator Inspect for wear or damage X Batteries Replace X NOTES: • Severe or high cycle usage will require more frequent maintenance checks. • Limits may have to be reset after any major drive chain adjustments. • If lubricating chain, use only lithium spray. Never use grease or silicone spray. • It is suggested that while at the site voltage readings be taken at the operator. Using a digital voltmeter, verify that the incoming voltage to the operator it is within ten percent of the operator's rating. BATTERIES Batteries will degrade over time depending on temperature and usage. For best performance, the batteries should be replaced every 3 years. Use only LiftMaster part 29-NP712 for replacement batteries. The operator comes with two 7AH batteries. Two 33AH (A12330SGLPK) may be used in place of the 7AH batteries. The batteries contain lead and need to be disposed of properly. Batteries do not perform well in extremely cold temperatures. The operator alarm will beep 3 times with a command if the battery is low. DRIVE CHAIN Over time, the drive chain on the operator will stretch and need to be tightened. To tighten the drive chain adjust either of the two chain eye bolts. NOTE: The chain should have no more than 1 inch of sag for every 10 feet of chain length. 33