LiftMaster RSL12V RSL12V Installation Manual - Page 18

ADJUSTMENT » LEARN LIMITS SINGLE GATE RIGHT-HAND SIDE 1 Close the gate. 2 Press and release the LEARN LIMITS button. The SET OPEN LIMIT LED will blink. PROGRAM OPEN 3 Press and hold the GATE 1 left button to move the gate to the desired OPEN position. When the gate is in the desired position, release the button. NOTE: The GATE 1 right and left buttons can be used to jog the gate back and forth as needed. 4 When gate is in the desired OPEN position, press and release the LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS LED will blink. PROGRAM CLOSE 5 Press and hold the GATE 1 right button to move the gate to the desired CLOSED position. When the gate is in the desired position, release the button. NOTE: The GATE 1 right and left buttons can be used to jog the gate back and forth as needed. 6 When gate is in the desired CLOSED position, press and release the LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS LED will stop blinking. Programming is now complete. If the SET OPEN LIMIT LED continues to blink, repeat programming. If the problem continues, see below. Test the limits by pressing the SINGLE BUTTON to open and close the gate. 1 PrOopuetsritdye ProInpseirdtye 3 GATE 1 Left Button DIAGNOSTIC 4 LEARN LIMITS Button SET OPEN LIMIT GATE 1 SET CLOSE "BEEP" SET CLOSE LIMIT ProInpseirdtye 5 GATE 1 Right Button DIAGNOSTIC GATE 1 6 LEARN LIMITS Button SET OPEN LIMIT SET CLOSE "BEEP" ProInpseirdtye GATE 1 SET OPEN LIMIT SET CLOSE LIMIT LEARN LIMITS GATE 2 2 LEARN LIMITS Button PrOopuetsritdye PrOopuetsritdye IF THE LIMITS WILL NOT PROGRAM 1 Disconnect the operator by pressing the reset switch to RESET/DISCONNECT. 2 Manually close the gate. 3 Remove the learn limit cover and move the learn limit nut to the center position. 4 Press the reset switch to NORMAL OPERATION. Program the limits again. 17 Learn Limit Switch Learn Limit Cover Learn Limit Nut