LiftMaster RSL12VDC RSL12VDC Installation Manual - Page 40
Install The Solar Panel, Wire The Solar Panels
View all LiftMaster RSL12VDC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
APPENDIX STEP 6 continued... SOLAR PANEL(S) INSTALL THE SOLAR PANEL 1. Position solar bracket on mounting surface. Mark and drill holes. 2. Insert two bolts into the track located on the back of the solar panel(s). 3. Slide bolts in track away from bolt hole and align both bolts. 4. Secure solar panel(s) to solar bracket using two washered nuts. 5. Secure solar panel(s) assembly to mounting surface using appropriate hardware. Mounting Surface Mounted Panel Must Face South Mounting Surface WIRE THE SOLAR PANELS 1. Locate the J15 plug on the control board and unplug it from the control board (it will not be used). 2. Set the new 33AH battery in the operator. 3. Route the battery wires (the longer set of wires) from the J15 plug (new wire harness) through the back of the electrical box. Connect the red wire to the positive (+) terminal of the battery. Connect the black wire to the negative (-) terminal of the battery. 4. Connect the shorter red wire (+) from the J15 plug (new wire harness) labeled DC Power to the red wire on the solar panel. Connect the shorter black (-) wire from the J15 plug (new wire harness) labeled DC Power to the black wire on the solar panel. 5. Plug the J15 plug (new wire harness) into the J15 input on the control board. NOTE: You may see a small spark when plugging the J15 plug into the board. If necessary, connect additional 12V solar panels in parallel to achieve the desired wattage (30W maximum). Proceed to the Dual Gate section (if applicable) or proceed to the Adjustment section. J15 Plug (new wire harness, Model K94-37236) Black Wire (-) Diode + - 20W Solar panel installation 33AH Battery -+ Black Wire (-) Red Wire (+) + Red Wire (+) + - - 30W Solar panel installation 39