Lowrance Elite-9 Ti Installation Manual EN - Page 34

Data sources - manual source selection Manual selection is generally only required where there is more than one source for the same data, and the Auto configure selected source is not the one desired. Pressing the menu key when the desired source is highlighted provides additional options: Configure device Configure device is not available on the ELITE-5Ti. Additional device options can be configured from both the Data source menu or from the Device list. For further information, refer to "Device list" on page 35. Scope Scope is not available on the ELITE-5Ti. The active data source under any given category, can be set to be Global or Local. When a source is set as Global, it will be used by all displays on the network. When a source is set as Local, it will only be used by the display that selected it as the source. Ú Note: If changing a display from a Global source to a different Local source, change the Scope setting to Local before changing the selected source, otherwise all other displays will be changed over to the new source. Ú Note: Local and Global data settings apply to the selected data source only. It is not possible to discretely set whether a data source is Global or Local if it is not the active source on the display being operated. Reset Global/Local Reset Global and Reset Local are not available on the ELITE-5Ti. Selecting Reset Global runs an Auto data source selection, and overrides all previous manual source selections made on all networked devices. Selecting Reset Local reverts all data source selections on the unit being used to the Global source settings available from other networked units. 34 Software Setup | ELITE Ti Installation Manual