Lowrance StructureScan HD Transom Installation Manual - Page 8
Transom mount - skimmer
View all Lowrance StructureScan HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Transom mount The StructureScan transducer can be mounted just like a skimmer transducer, where it is in the water when you are on plane or can be mounted so it is only in the water, when you are moving at trolling speed. Transom Mount Supplies (not included) 1/8" Drill bit (Transom mount pilot holes) Marine grade above- or belowwaterline sealant Transom Mount (Aluminum Hull) Supplies (not included) M4 Machine Screws Marine grade above- or belowwaterline sealant Starboard (prevents corrosion between bracket and aluminum hull) To Mount StructureScan transducer on Transom: 1. Choose a transducer location and then route the transducer cable to the location where the StructureScan module will be installed. 2. Place the transducer bracket against the transom and then align the bottom of the transducer with the bottom of boat. Use a pencil to mark the pilot holes through the slots in the transducer bracket. 3. Drill the pilot holes into the boat's transom. 4. Apply a high-grade above- or below-waterline sealant to the pilot holes. 5. Align the bracket slots over the pilot holes and fasten the bracket to the transom using your drill and the supplied screws. 6. To make adjustments to transducer position, loosen the screws and slide bracket up or down. 7. Connect the transducer cable to the StructureScan module sonar port. 8 | StructureScan HD | Installation