Magnavox 27PT5245 User manual, English (US) - Page 5

Basic Cable TV Connection The Cable TV signal into your home may be a single cable (75 ohm) or may include a Cable Box. In either case, the connection to the TV is easy. If your Cable TV signal comes directly via a 75Ω coaxial cable, use the following steps. 1 Connect the Cable TV signal to the 75 OHM ANTENNA INPUT jack on the rear of the TV. Screw it down tight. DVD Y Cb Cr IN 2 OUTPUT 75 OHM ANTENNA INPUT VIDEO L (MONO) AUDIO R 2 Plug theTV's power cord into a power outlet and turn on the TV. Set TV/CABLE to CABLE as detailed on page 11. Refer to AUTO PROGRAM to set up your available TV channels. Details are on page 12. Cable TV Company 1 75 OHM ANTENNA INPUT If you have a Cable Box, use the following steps. 1 Connect the Cable TV signal to the IN jack on the Cable Box. 2 Connect a separate coaxial cable to the OUT jack on the Cable Box and to the 75 OHM ANTENNA INPUT jack on the rear of the TV. 3 Plug the TV's power cord into a power outlet and turn on the TV. Set TV/CABLE to CABLE as detailed on page 11. 4 Set the TV to channel 3 or 4 (the same as the Channel 3/4 switch on your Cable Box if applicable). Change channels at the Cable Box. Cable TV Company Cable Box DVD Y Cb Cr IN 2 OUTPUT 75 OHM ANTENNA VIDEO INPUT L (MONO) AUDIO R 75 OHM ANTENNA INPUT Helpful Hints An RF coaxial cable (to connect the Cable Box to the TV) may be supplied by the Cable TV company. It is not supplied with the TV. You can connect a Satellite Receiver the same way you would connect a Cable Box. Your Cable Box may have separate Audio and Video Out jacks instead. If so, use audio and video cables to connect the AUDIO/VIDEO OUT jacks of the Cable Box to the AUDIO/VIDEO IN 2 jacks on the rear of the TV. Press TV/AV/EXIT on the TV's remote control to set the TV to the VIDEO 2 channel. Change TV channels at the Cable Box. 5