Makita HR5210C Owners Manual - Page 4

･ hertz ･ alternating current ･ no load speed ･ Class II Construction ･ revolutions or reciprocation per minute ･ number of blow • This switch functions only when setting the tool in symbol action mode. When using the tool in the hammering mode for a long time, the slide switch is available. To start the tool, push the "I (ON)" side of the switch lever. To stop the tool, push the "O (OFF)" side of the switch lever. 1. Switch lever 1 1 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1. Switch trigger 007837 Speed change 1. Adjusting dial 1 1 007838 007858 FOR MODEL HR5211C CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. FOR MODELS HR5210C/ HR5201C Trigger switch CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. • This switch functions when setting the tool in symbol and symbol modes. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. Slide switch CAUTION: • Before plugging in the tool, always check to see that the tool is switched off. The revolutions and blows per minute can be adjusted just by turning the adjusting dial. The dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the revolutions/blows per minute. Number on adjusting dial 5 4 3 2 1 007903 Revolutions per minute 260 240 190 150 130 Blows per minute 2,150 2,000 1,600 1,250 1,075 CAUTION: • If the tool is operated continuously at low speeds for a long time, the motor will get overloaded, resulting in tool malfunction. • The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. 4