Makita LD050P LD050P Instruction Manual - Page 10

en Message Codes If the message Error does not disappear after switching on the device repeatedly, contact the dealer. If the message InFo appears with a number, press the Clear button and observe the following instructions: No. Cause Correction 204 Calculation error Perform measurement again. 252 Temperature too high Let device cool down. 253 Temperature too low Warm device up. 255 Received signal too Change target surface weak, measuring (e.g. white paper). time too long 256 Received signal too Change target surface high (e.g. white paper). 257 Too much background light Shadow target area. 258 Measurement outside of measuring range Correct range. 260 Laser beam inter- Repeat measurement. rupted Care Safety Instructions • Clean the device with a damp, soft cloth. The person responsible for the instrument • Never immerse the device in water. must ensure that all users understand • Never use aggressive cleaning agents these directions and adhere to them. or solvents. Areas of responsibility Responsibilities of the manufacturer of the original equipment: Makita Corporation Anjo, Aichi 446-8502 Japan / Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium Internet: www.makita.com The company above is responsible for supplying the product, including the User Manual in a completely safe condition. The company above is not responsible for third party accessories. Responsibilities of the person in charge of the instrument: • To understand the safety instructions on the product and the instructions in the User Manual. • To be familiar with local safety regulations relating to accident prevention. • Always prevent access to the product by unauthorised personnel. 10 Makita LD050P