Makita LD050P LD050P Instruction Manual - Page 12

en Safety Instructions FCC statement (applicable in U.S.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Laser classification The device produces visible laser beams, which are emitted from the instrument: It is a Class 2 laser product in accordance with: • IEC60825-1 : 2014 „Radiation safety of laser products" Laser Class 2 products: Do not stare into the laser beam or direct it towards other people unnecessarily. Eye protection is normally afforded by aversion responses including the blink reflex. ƽ WARNING Looking directly into the beam with optical aids (e.g. binoculars, telescopes) can be hazardous. ƽ CAUTION Looking into the laser beam may be hazardous to the eyes. Description Maximum peak radiant output power Wavelength Pulse duration Pulse repetition frequency Beam divergence Value 0.95 mW 635 nm > 400 ps 320 MHz 0.16 x 0.6 mrad Labelling ® LD050P Makita xxxxxxx xxxxxxx xxxxxxx Made in Hungary Batteries: 2 x AAA Complies with 21CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007 Subject to change (drawings, descriptions and technical data) without prior notice. 12 Makita LD050P