Makita XNJ01 XNJ01Z Instruction Manual - Page 5

FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1. Button 1 2. Red indicator 2 3. Battery cartridge 3 013284 CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. • Hold the tool and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the tool and the battery cartridge firmly may cause them to slip off your hands and result in damage to the tool and battery cartridge and a personal injury. To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator on the upper side of the button, it is not locked completely. CAUTION: • Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. • Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly. Battery protection system The tool is equipped with a battery protection system. This system automatically cuts off power to the motor to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: • Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before turning the tool on again. • Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. NOTE: The overheat protection works only with a battery cartridge with a star mark. 1 1. Star marking 012128 Changing the die position 1 2 3 1. Die holder 2. Lock nut 3. Loosen 4. Wrench 4 013275 The die holder position can be changed 360°. To change it, proceed as follows. 1. Loosen the lock nut with the wrench provided. 2. Pull the die holder slightly and turn it to the desired position for operation. 3. Tighten the lock nut to secure the die holder in the desired position. There are four positive stops at 90° each: 0°, 90° left and right and 180°. To position the die to any of these positive stops: 1. Loosen the lock nut with the wrench provided. 2. Pull the die holder slightly and depress lightly while turning it to the desired position. The die holder will lock into one of the positive stop positions as desired. 3. Turn the die holder slightly to make sure that it is positively locked into position. 4. Tighten the lock nut to secure the die holder. 5