Makita XNJ01 XNJ01Z Instruction Manual - Page 7

1. Punch Cutting method 1 5 2. Punch holder 3. Screw 2 6 4. Hex wrench 5. Loosen 4 6. Tighten 3 013274 To install the punch and die, insert the punch into the punch holder so that the notch in the punch faces toward the screw. Tighten the screw to secure the punch. Install the die on the die holder. Tighten the bolts to secure the die. 1. Punch 2. Notch 1 013285 Hold the tool so that the cutting head is at a right angle (90°) to the workpiece being cut. Move the tool gently in the cutting direction. Cutouts 2 004781 Then install the die holder on the tool so that the punch is inserted through the hole in the die holder. Tighten the lock nut to secure the die holder. After replacing the punch and die, lubricate them with machine oil and run the tool for a while. 1. Bolts 2. Die 1 4 3. Punch 2 4. Die holder 013286 Cutouts can be done by first opening a round hole over 21 mm (13/16") in diameter which the cutting head can be inserted into. Cutting the corrugated or trapezoidal sheet metals 1 3 2 004782 OPERATION Pre-lubrication 3 Coat the cutting line with machine oil to increase the punch and die service life. This is particularly important 5 when cutting aluminum. 4 1. From the top view 2. Cutting at an angle to grooves 3. Cutting perpendicular to grooves 4. From the side view 5. Corrugated or trapezoidal sheet metal 013280 Set the die position so that the die faces the cutting direction either when cutting at an angle or 7