Makita XVJ03Z XVJ03Z Instruction Manual - Page 6

Position Cutting action 0 Straight line cutting action Small orbit cutting action Medium orbit cutting action Large orbit cutting action 006376 Switch action Applications For cutting mild steel, stainless steel and plastics. For clean cuts in wood and plywood. For cutting mild steel, aluminum and hard wood. For cutting wood and plywood. For fast cutting in aluminum and mild steel. For fast cutting in wood and plywood. 1 2 1. Lock-off button 2. Switch trigger 007484 1 B 1. Lock-off button A 007485 CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. • When not operating the tool, depress the lock-off button from A side to lock the switch trigger in the OFF position. To prevent the switch trigger from accidentally pulled, the lock-off button is provided. To start the tool, depress the lock-off button from B side and pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. After use, always press in the lock-off button from A side. Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center. Lighting up the lamps CAUTION: • Do not look in the light or see the source of light directly. To turn on the lamp, pull the trigger. Release the trigger to turn it off. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing saw blade CAUTION: • Always clean out all chips or foreign matter adhering to the blade and/or blade holder. Failure to do so may cause insufficient tightening of the blade, resulting in a serious personal injury. • Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. • Tighten the saw blade securely. Failure to do so may cause a serious injury. • When you remove the saw blade, be careful not to hurt your fingers with the top of the blade or the tips of workpiece. To install the blade, open the tool opener to the position shown in the figure. 1. Tool opener 1 001909 Keeping that situation, insert the saw blade into the blade clamp as far as the two protrusions of the blade can not be seen. 6