Marantz PM-15S1G PM-15S1G User Manual - English - Page 13
Display
View all Marantz PM-15S1G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH NAMES AND FUNCTIONS OF PARTS !2 REC OUT Button This button turns the signals output from the RECORDER 1 and 2 OUT jacks on the rear panel ON and OFF. When output is ON, the center of the button is lit a blue color. For instructions on how to record, see "RECORDING" on pg. 15. When RECORDER 1 is selected as the input source, signals are not output to the RECORDER 1 OUT jack. The same goes for the RECORDER 2 OUT jack when RECORDER 2 is selected as the input source. !3 PHONO MC Button This button switches the phono equalizer between MC and MM. When MC is set, the center of the button is lit a blue color. Set the phono equalizer amplifier according to the type of cartridge you use. !4 Illumination Lamp The side illumination casts a blue light over switches and buttons. It can be turned ON and OFF from the DISPLAY button. For instructions on how to operate the side illumination, see "HOW TO OPERATE THE ILLUMINATION LAMP" on pg. 17. DISPLAY Volume Level Indication Max OPERATE !5 Power Indicator This indicator is lit a blue color while power to the PM15S1 is ON. !6 Display Panel Approximately 3 seconds after power to the PM-15S1 is activated, the ID set for the PM-15S1 is displayed here. After that, the top line displays the input source, while the bottom line displays the volume level. The volume level is displayed as an attenuation level (dB). 0.5 dB steps Turn the VOLUME knob on the PM-15S1 to the right or press the VOLUME 3 button on the remote controller. Turn the VOLUME knob on the PM-15S1 to the left or press the VOLUME 4 button on the remote controller. Min The display panel also displays left-right volume level balance. For instructions on how to trim volume level, see "TRIMMING" on pg. 18. The display panel also displays messages in response to PM-15S1 operation. !7 OPERATE Indicator This indicator indicates the operating status of the PM15S1. When the ID is set to "0" for standalone operation, it is lit a red color. When multiple PM-15S1s are connected by FCBS, only the OPERATE indicator of the master PM15S1 (ID 1) lights a red color. Slave PM-15S1s whose OPERATE indicator does not light a red color cannot be used to operate other units in sync. For more information on the FCBS, see "ABOUT FCBS" on pg. 16. 9