Marantz PM6004 User Manual - Page 15

Getting started Basic connections Basic operation Advanced connections Advanced operations Troubleshooting Specifications Explanation terms Index Advanced operations ENGLISH Remote control settings • When you connect a remote control receiver unit (purchased separately) to the REMOTE CONTROL IN terminal of this unit, use the following procedure to disable the remote sensor function of this unit. • The remote sensor function of remote control signals is enabled by default. Setting remote control codes This unit and its supplied remote control are equipped with three sets of remote control codes. When two or three amplifiers are used in the same location, you can set a different remote control code to pair each unit and remote control so that you can operate the selected amplifier from the remote control without interference from other signals. • When the unit is shipped from the factory, the main unit and remote control are set to "AMP1". Setting remote control codes for this unit Hold down [AMP] and press [DISPLAY]. • This operation sends the remote control code set for the remote to this unit. • After you set the remote control code for this unit, the indicators on the unit blink as shown below. AMP1 ：The PHONO indicator flashes three times. [AMP] nnDisabling the sensor function of the remote control While the remote sensor function of this unit is enabled, press and hold for about 5 seconds. The MUTE indicator blinks three times and the remote sensor function is disabled. [2] [1] [3] AMP2 ：The TUNER indicator flashes three times. nnEnabling the remote sensor function While the remote sensor function of this unit is disabled, press and hold for about 5 seconds. The RECORDER 2 indicator blinks three times and the remote sensor function is enabled. NOTE • If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you do, you will not be able to operate this unit using the remote control. • If you unplug the power cord while the remote sensor function of this unit is disabled, the remote sensor function is enabled. [DISPLAY] Setting remote control codes for the remote control To set the remote control to AMP 2 Press and hold [AMP] and number button [2] for 5 seconds or longer. To set the remote control to AMP 3 Press and hold [AMP] and number button [3] for 5 seconds or longer. AMP3 ：The CD indicator flashes three times. NOTE To restore the remote control code default setting, press and hold [AMP] and number button [1] for 5 seconds or longer. 11