Marantz SA-KI Ruby Owners Manual English - Page 25

Overview Connections Playback Phones The headphones circuit operation can be stopped to minimize noise from the headphones circuit which could interfere with the analog audio output signal. On (Default): Off: Enable the headphones output. Disable the headphones output. 0 When not using headphones, you can enjoy higher quality sound with Off mode. HP AMP Gain Set the gain of the headphone amplifier. Set this according to the impedance of the connected headphones. It is recommended that this is set on the "Low" side if the headphones have low impedance and on the "High" side if they have high impedance. Low (Default): Middle: High: Set the gain of the headphone amplifier to "Low". Set the gain of the headphone amplifier to "Middle". Set this if the volume is too low at the factory default setting. Set the gain of the headphone amplifier to "High". Set when there is insufficient volume, even when the gain setting is "Middle". NOTE 0 The headphone volume varies depending on the "HP AMP Gain" setting. Decrease the volume or mute the audio first if changing this setting while listening to audio. Resume Play When the playback media mode is switched, the USB memory device is disconnected and then connected, or the power is turned off and then back on during USB memory device playback, the unit memorizes the point where playback stopped (resume information) so that playback can resume from the beginning of that track. On (Default): Off: Resume playback is set. Resume playback is not set. NOTE 0 Resume playback works even if the USB memory device is disconnected and then reconnected. However, if a different USB memory device is connected, the resume information for the previous USB memory device is deleted. 0 The resume information may be deleted when the USB memory device is removed and files are added or deleted. 0 Press 2 while playback is stopped to delete the resume information. "Resume Off" is displayed. 0 Resume information is not recorded when the power is turned off by pressing X during USB memory device playback. AutoStandby Sets whether to automatically switch the unit to the standby mode when the unit remains in the stop mode for more than 30 minutes. On: Off (Default): Enable Auto Standby mode. Disable Auto Standby mode. ENGLISH Timer Play This unit can perform timer play by cooperating with your timer device. ("Connecting the timer device" (v p. 10)) On: Off (Default): Timer play is set. Select the playback media mode to be used for timer play. Timer play is not set. n Using the timer play function 1. Turn on the power of the connected components. 2. Load a disc or connect a USB memory device. 3. Switch the media mode of this unit to the media to be played using the timer. 4. Switch the amplifier's function to input from the connected unit. 5. Set the audio timer for the desired times. 6. Turn the timer on. The power of the components connected to the timer turns off. When the set time is reached, the power of the different components automatically turns on and playback starts from the first track. NOTE 0 For connection to audio timer and it's operation, please refer to the instruction manual of your audio timer. 0 The timer play does not support the random playback, repeat playback or program playback. Settings Tips Appendix 24