Marantz SA8005 Owner's Manual in English - Page 55

Contents Connections Playback USB Resume This unit stores the point at which playback of a file was stopped previously, and starts playback from the same point the next time playback is started. On (Default) : Resume playback is set. Remote : R esume playback is not set. NOTE • Resume playback works even if the USB memory device is disconnected and then reconnected. However, if a different USB memory device is connected, the resume information for the previous USB memory device is deleted. • The resume information may be deleted when the USB memory device is removed and files are added or deleted. Digital Out Switches the digital audio output on/off. On (Default) : U se the digital audio output connector. Off : D o not use the digital audio output connector. % • When digital output is turned off, the "DOFF" indicator lights up on the display. • The "Digital Out" has a memory retention function where the settings remain stored and unchanged even when the disc is changed or the power is turned off. Settings Tips Appendix Audio Out You can set whether to fix (Fixed) or vary (Variable) the analog audio output level. Fixed (Default) : Fixes the analog audio output level (0 dB). Variable : You can adjust the analog audio output level using the VOLUME df buttons on the remote control. % • When you enter "Fixed" or "Variable", "Are You Sure?" is displayed for approximately 3 seconds on the display. Select "OK" to set or "Cancel" to cancel the selection. • The remote control needs to be set in order to adjust the analog audio output level (vpage 57). • When the analog output level is adjusted, the headphone volume also changes. When using the headphones, adjust the volume to a suitable level by also using the headphone volume control knob. • When "Variable" is selected, the analog audio output level can be adjusted to --- dB (minimum) and between the range from -99 dB - 0 dB (Default：-40 dB). NOTE • Note that the analog audio output level changes to the maximum (0 dB) when the analog audio output setting is changed from (Variable) to (Fixed). • Before changing the settings, turn the volume of the amp connected to the analog audio output terminals (AUDIO OUT) and headphones connected to the unit to the minimum volume. Front panel Display Rear panel 55 Remote Index