Marantz SR-18EX User Guide - Page 15
REAR PANEL CONNECTIONS, Monitor. VIDEO/S-VIDEO output jacks
View all Marantz SR-18EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH REAR PANEL CONNECTIONS All connections to the rear panel should be made with the entire system powered off. To avoid errors, it is advisable to connect one cable at a time between the various components. 11 20 10 16 17 18 14 1 2 13 21 COAX OUT OPT OUT DIG .1 IN DIG .2 IN DIG .3 IN DIG .4 IN DIG .5 IN DIG .6 IN FRONT L FRONTR SURROUND LSURROUNRD (FRONT) L (FRONTR) MAIN MINAIN FM (75Ω) GND AM L R FRONT FRONT TV S2TVIN S2 IN LD S2LDIN S2 IN PRE OPURTE OUT L R L R SUB Y SURROUND CENTER SURROUND BACK WOOSFUEBR SURROUND S - VIDEO S - VIDEO CENTER SURROUND BACK WOOFER VCR1 IN COMPONENT VIDEO COMCPO r NENTY VIDEO Cr DVD SD2 VIND S2 IN VCR1 SV2CRIN1 S2 IN VIDEO VIDEO MONITOR OUT VCR1 OVUCTR1 OUT DSS / VCR2 DSS / VCR2 MONI. DSSS2 /INVCR2 DOSSUT/ VCR2 S2MOOUNTI. S2 IN OUT S2 OUT MONI. MONI. MULTI RMOUOLMTI ROOM DIRECT IN SUB CENTER WOOFER SURROUND L R R FRONT L (SURR. BACK) ANTENNA ANTENNA Cr Cr DVD IDNVD DSS / VDCRSS2 / IVNCR2 R SURROUND L CENTER SPEAKER SPEAKER SYSTEMS 8 OHMS SYSTEMS 8 OHMS AC OUTLETS 1A2C0VO6U0THLZETS SWITC12H0EVD 16200HWZ1A SWITCHED 120W 1A AC INLET AC INLET UNSWITCHED 120W 1A UNSWITCHED 120W 1A L R TV LD DVD IN - VCR1 - OUT IN - DSS/VCR2 - OUT TV DVD IN VCR1 OUT IN DSS/VCR2 OUT AUDIO AUDIO IN OUT OUT AUDIO AUDIO MULTI RMOUOLMTI ROOM CD CD IN - TAPE - OUT IN - CD-R / MD - OUT REMOTE MULTI IN APE OUT IN CD-R / MD OUT REMOTE MUL AUDIO REMOTE CONTROL AUDIO REMOTE CONTROL 19 9 5 8 6 12 3 15 1 FM antenna terminal (75 ohms) Connect an external FM antenna with a coaxial cable, or a cable network FM source. 2 AM antenna and ground terminals Connect the supplied AM loop antenna. Use the terminals marked "AM" and "GND". The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best 3 Three analog audio inputs CD, TAPE, and CD-R/MD : Connect the audio outputs of your source components to the input jacks on the receiver. 4 Two analog audio outputs for audio source equipment TAPE and CD-R/MD : Connect each output to the audio inputs (REC in) of your recording equipment. 5 Five analog audio inputs for video source equipment TV,LD,DVD, VCR1, and DSS/VCR2 : Connect each input to the audio outputs of your video source equipment. 6 Two analog audio outputs for video source equipment VCR1, and DSS/VCR2 : Connect each output to the audio inputs (REC in) of your video recording equipment. 4 22 23 7 24 25 7 6-Channel Inputs If an external digital audio decoder is used, connect the outputs of that decoder to these jacks. Note that front L&R channels are common used in analog audio inputs, use the assigned input in OSD setup menu system. (See page 17 "System setup 1/2".) 8 Five video inputs TV,LD,DVD, VCR1, and DSS/VCR2 : Connect each input to the video outputs of your video source equipment. 9 Two video outputs VCR1, and DSS/VCR2 : Connect each output to the video input (REC in) of your video recording equipment. 10 Five S-video inputs TV,LD,DVD, VCR1,and DSS/VCR2 : Connect each input to the S-video outputs of your video source equipment. 11 Two S-video outputs VCR1, and DSS/VCR2 : Connect each output terminals to S-video input (REC in) of your video recording equipment. 12 Monitor. (VIDEO/S-VIDEO) output jacks Connect this jack to the composite or S-Video input of a TV monitor or video projector to view the on-screen menus and the output of any standard video source selected by the receiver's video switcher. 10