Marantz SR8400 SR8400 User Manual - Page 12

ENGLISH I NAME indicator This is displayed when the remote control is in renaming mode. J LEARN indicator This is displayed when the remote control is in learning mode. REMOTE CONTROL RANGE The distance between the transmitter of the remote control and the IR SENSOR of the SR8400 should be less than 5 meters. If the remote control is pointed in a direction other than the IR SENSOR or if there is an obstacle between them, use of the remote control may not be possible. Remote-controllable range SR8400 Approx. 5 m 60° CH CLEAR OK PREV 7 4 DISP 0 1 7.1CH TESTMENU 2 CH.SEL GUIDE 5 ATT 8 OSD 3 SURREXIT 6 SPK-AB 9 SLEEP MUTE TV TUNER TAPE 1 AUX1 Learning LIGHT RemRoCte14C0o0ntroller DVD CD VCR CD-R AUX2 MD AMP 2 DSS MEMO VOL OFF ONP/OOFFWER SOURCE ON M D1 D2 D3 D4 D5 Remote control unit (RC1400) LOADING BATTERIES The life of the batteries used with the remote control is about 4 months with normal use. Also be sure to replace batteries earlier when you notice that they are getting weak. 1. Remove the back cover. 3. Close the cover until it clicks. Note: Do not use old batteries and new batteries together. This can result in corrosion or leakage of battery fluid. The supplied manganese batteries are for checking operation. Usage of alkaline batteries is recommended. When discarding batteries, be sure to follow the local regulations for your area. Do not put batteries in a fire. BATTERY REPLACEMENT INTERVAL Under normal usage, alkaline batteries last approximately four months. When the batteries wear out, a battery mark is displayed on the LCD. Although the remote control can still be used when the battery mark is displayed, the batteries should be replaced as soon as possible. The LCD eventually starts to flash when buttons are pressed, the remote control will be unable to transmit signals or learn codes. • This remote control uses non-volatile memory so that the learned codes and macro programs are retained even if the batteries are removed. Reset the clock after replacing the batteries. Safety Precautions for Batteries Be sure to always observe the following precautions to prevent fluid leakage, overheating, fire, breakage, accidental ingestion, and other accidents. • If the batteries are left unused for a long period of time, the battery fluid may leak or the batteries may corrode. • Do not use the batteries in the remote control with the plus and minus polarity reversed. • Do not attempt to recharge, heat, or disassemble the batteries. Do not put the batteries in a fire. • Do not use the remote control with old batteries or worn-out batteries inserted. • Do not use different types of batteries or mix old and new batteries in the remote control. • If the remote control is not operating properly, replace the batteries with new ones. • If any of the batteries are leaking, completely wipe up all leaked battery fluid, and then replace the batteries with new ones. 2. Insert the new batteries (AAA type) with correct (+) and (-) polarity. 9