Maytag MDB9959SK Owners Manual - Page 14

5. Built-up floors - add shims as needed Shim ELECTRICAL CONNECTION - For Direct Wire, begin with Step 7 - For Power Cord, wait until Step 18 7. Direct wire - route cable Note: The wood runners that come with the shipping base work well for shims. Built-up floors: If the kitchen floor is higher than the cabinet opening's floor - for example, the kitchen floor tile does not extend into the cabinet opening - add shims, as needed, in the area shown to bring cabinet floor up to same level as the kitchen floor. NOTE: Shims must be securely attached to floor to avoid movement when the dishwasher is in use. 6. If installing into a 335/8" (85.4 cm) opening (15.2 6" cm) If installing with direct wire, route the cable as shown. Do not connect the wire to the product at this time. This connection will be made later, after the unit is installed into the cabinet opening. Route cable from power supply through cabinet hole. (Cable must extend to the right front side of cabinet opening.) Tape cable to the floor in area shown. This will prohibit cable from moving when dishwasher is moved into cabinet opening. Cut insulation blanket along perforation for cabinet opening height of 335/8" (85.4 cm). For other cabinet opening heights, do not cut the insulation blanket. 14