Maytag MED6300TQ Use and Care Guide - Page 18
Level
UPC - 883049060958
View all Maytag MED6300TQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CONNECT VENT 1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Check that the vent is secured to exhaust hood with a 4" (102 cm) clamp. 2. Move dryer into its final location. Do not crush or kink vent. 3. (On gas models) Check that there are no kinks in the flexible gas line. 4. Once the exhaust vent connection is made, remove the corner posts and cardboard. LEVEL DRYER Check tile levelness of the dryer by first placing a level on the top of the dryer near the console, REVERSE DOOR SWING You can change your door swing from a right-side opening to a left-side opening, if desired. 1. Place a towel or soft cloth on top of the dryer or work space to protect the surface. Remove the door assembly 1. Open the dryer door. 2. Remove the bottom screw from each of the 2 hinges that attach the dryer door to the front panel of the dryer. 3. [oosen the top screw from each of the 2 hinges in Step 2. A B Then, by placing a level ill the crease on the side of the dryer between the top of the dryer and the dryer cabinet, check the levelness from front to back. A B A. _oosd!l} thd!s(! scF(!ws. B. Rd!movd! t]l(!sd! 8c1(!w8. 4, Remove the dryer door and the hinges by lifting upward on the door. I.ay the door on a flat, protected surface, with the inside of the door facing up. Remove remaining 2 loose screws from dryer front paneh If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs up or down and check again for levelness. 18