Maytag MGD4200BW Installation Guide - Page 21

2. Move the door strike 4. Remove hinge and latch from inner door Latch Using a TORX® T25 screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Remove the 4 screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. 3. Remove inner door from outer door Release tab Hinge Using a TORX T25 screwdriver, remove the 3 TORX screws securing the latch plate and the 5 screws holding the hinge assembly in place. 5. Reinstall hinge and latch on opposite sides Latch Release tab Latch Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside. NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. Using a TORX T25 screwdriver, reinstall the latch plate and hinge assembly on the opposite sides from which they were removed. 21