Maytag MGD6000XR Owners Manual - Page 12

CYCLE STATUS INDICATORS + - temp level dryness level damp signal 11-cycle model shown The Cycle Status Indicators show the progress of a cycle. Check Lint Screen The Check Lint Screen indicator will light when the dryer is turned on as a reminder to clean the lint screen before each load. Sensing The Sensing indicator will light during Sensor Cycles to indicate that the moisture sensor on the dryer is operating. This indicator will not light during Timed Cycles or options such as Wrinkle Prevent™. Wet The load is still wet and/or the cycle just started. Damp This indicator shows that the load is partially dried and items that you may wish to hang up or iron while still damp may removed. Cool Down The dryer has finished drying with heat, and is now tumbling the load without heat to cool it down and reduce wrinkling. Steam (on some models) This indicator will light when the Steam Boost function is active. NOTE: Steam is not available on all models or on all cycles. Reduce Static (on some models) This indicator will light when the Reduce Static function is active. NOTE: Reduce Static is not available on all models or on all cycles. Done This will indicate that the selected cycle has ended and the load may be removed from the dryer. If the Wrinkle Prevent option has been selected, the dryer may continue to tumble the load, even if the Done indicator is lit. Wrinkle Prevent™ This indicator will light if the Wrinkle Prevent option has been selected and is running. The dryer will continue to tumble the load for up to 150 minutes (depending on model and selected settings) after the cycle has ended. ADDITIONAL FEATURES USING THE DRYING RACK To obtain a drying rack for your dryer, follow the instructions included in your dryer drum. Remove and discard any packing material before use. Use the Drying Rack for items that you do not want to tumble dry, such as sweaters and tennis shoes. When you use the drying rack, the drum continues to turn, but the rack remains stationary. The drying rack is intended for use with the Timed Dry cycles only. The drying rack cannot be used with Sensor cycles. To use the drying rack: IMPORTANT: Do not remove the lint screen. 1. Open dryer door. 2. Align the two hooks on the front of the drying rack with the holes in the dryer door opening and press down fully into holes. Rest the rear support on the dryer back ledge. 3. Place wet items on top of the drying rack. Allow space around items for air to circulate. The drying rack does not move, but the drum will rotate. Make sure items do not hang over the edges or between drying rack grille. 4. Close the door. 5. Select a Timed Dry/Air Only, or Low Temperature cycle. Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Only setting. 6. When the cycle is selected, the Estimated Time Remaining display shows the default time. You can change the actual time in the cycle by increasing or decreasing the cycle time. 7. Start the dryer. NOTE: Check the lint screen and remove any lint accumulated from items dried on the drying rack after the cycle is finished. 12