Maytag MHW4200BW Use & Care Guide - Page 14

WASHER CARE cont.

Get Maytag MHW4200BW PDF manuals and user guides View all Maytag MHW4200BW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

WASHER MAINTENANCE WASHER CARE (cont.) Cancellation of Clean Washer Cycle Operation: If the Clean Washer cycle is canceled by the user after it has been initiated, it may take up to 30 minutes for the washer to purge any affresh® Cleaner, chlorine bleach, or other chemistry from the wash system and to adequately rinse any remaining chemistry. The washer door will remain locked until the cancellation process has been completed. This ensures no cleaning chemistry will be carried over to the next wash cycle and reduces the potential for damage to subsequent loads of laundry or to the washer itself. Clean Washer Cycle Cancellation Procedure: 1. Touch POWER/CANCEL on the washer once. 2. The washer will begin to drain and rinse away the remaining cleaning chemistry. 3. The cycle will complete the cancellation process in approximately 30 minutes or less. 4. The washer then can be used to either repeat the Clean Washer cycle or to wash laundry using one of the regular wash cycles selected by the user. Cleaning the Dispensers After a period of using your washer, you may find some residue buildup in the washer's dispensers. To remove residue from the dispensers, remove the drawer and wipe the surfaces with a damp cloth and towel dry either before or after you run the Clean Washer cycle. Use an all-purpose surface cleaner, if needed. IMPORTANT: Dispenser is not dishwasher safe. Cleaning the Outside of the Washer Use a soft, damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your washer to help keep it looking new. Use mild soap and water. IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products. WASHER CARE (cont.) Removing the Dispenser To remove: 1. Pull dispenser drawer out until it stops. 2. Press down on the release tab and pull straight out to remove the dispenser. 3. Lift off cover panel by pulling straight up. To replace: 1. Slide cover panel back onto posts on dispenser. 2. Align edges of dispenser with guides in washer, then slide dispenser back into slot. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
14
WASHER CARE (cont.)
Cancellation of Clean Washer Cycle Operation:
If the Clean Washer cycle is canceled by the user after it has
been initiated, it may take up to 30 minutes for the washer
to purge any affresh
®
Cleaner, chlorine bleach, or other
chemistry from the wash system and to adequately rinse any
remaining chemistry. The washer door will remain locked until
the cancellation process has been completed. This ensures no
cleaning chemistry will be carried over to the next wash cycle
and reduces the potential for damage to subsequent loads of
laundry or to the washer itself.
Clean Washer Cycle Cancellation Procedure:
1.
Touch POWER/CANCEL on the washer once.
2.
The washer will begin to drain and rinse away the remaining
cleaning chemistry.
3.
The cycle will complete the cancellation process in
approximately 30 minutes or less.
4.
The washer then can be used to either repeat the Clean
Washer cycle or to wash laundry using one of the regular
wash cycles selected by the user.
Cleaning the Dispensers
After a period of using your washer, you may find some residue
buildup in the washer’s dispensers. To remove residue from the
dispensers, remove the drawer and wipe the surfaces with a
damp cloth and towel dry either before or after you run the Clean
Washer cycle. Use an all-purpose surface cleaner, if needed.
IMPORTANT:
Dispenser is not dishwasher safe.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to help keep it
looking new. Use mild soap and water.
IMPORTANT:
To avoid damaging the washer’s finish, do not use
abrasive products.
WASHER CARE (cont.)
Removing the Dispenser
To remove:
1.
Pull dispenser drawer out until it stops.
2.
Press down on the release tab and pull straight out to
remove the dispenser.
3.
Lift off cover panel by
pulling straight up.
To replace:
1.
Slide cover panel back
onto posts on dispenser.
2.
Align edges of dispenser
with guides in washer,
then slide dispenser
back into slot.
WASHER MAINTENANCE