Maytag MHW6630H Owners Manual - Page 48
Fresh Hold/Fresh Spin option is ON.
View all Maytag MHW6630H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com.tw. If you experience Possible Causes Washer not performing as expected (cont.) Washer not draining/ Using cycles with a slower spin speed. spinning; loads are still wet (cont.) Washer not loaded as recommended. The load may be out of balance. Not using HE detergent or using too much HE detergent. Door locked at end of wash cycle Small items may have been caught in the pump or stuck between the washer drum and the outer tub. There are too many clothes in the Overnight Wash & Dry cycle. Water remaining in washer after cycle. Fresh Hold/Fresh Spin option is ON. Door will not unlock Door locks when cycle has started. Incorrect or wrong wash or rinse temperatures Check for proper water supply. Washing many loads. Desired setting or option does not light Load not rinsed For best performance, not all settings are available with each cycle and some options cannot be used together. Check for proper water supply. Not using HE detergent or using too much HE detergent. Solution Cycles with slower spin speeds remove less water than cycles with fast spin speeds. Use the recommended cycle/ speed spin for your garment. A tightly packed or unbalanced load may not allow the washer to spin correctly, leaving the load wetter than normal. See "Cycle Guide" for load size recommendation for each cycle. Avoid washing single items. Balance a single item, such as a rug or jeans jacket, with a few extra items. Use only HE detergent. Suds from regular detergent or using too much detergent can slow or stop draining or spinning. Always measure and follow manufacturer's directions for your load. To remove extra suds, select DRAIN & SPIN with Extra Rinse. Do not add detergent. Check the drum for any items sticking through the drum holes. Empty pockets and use garment bags when washing small items. Only use the Overnight Wash & Dry cycle for 2-4 lightly soiled synthetic garments, athletic uniforms, or workout wear. Select DRAIN & SPIN to remove any water remaining in the washer. The washer door will unlock at the end of the drain. While this option is ON, the fan blows and the load is tumbled periodically for up to 12 hours. The door remains locked during this time. To unlock the door, cancel the Fresh Hold/ Fresh Spin option by touching POWER. If the "Add Garment" light is lit, touch START once. The door will unlock. Make sure hot and cold inlet hoses are not reversed. Both hoses must be attached to both washer and faucet, and have both hot and cold water flowing to inlet valve. Check that inlet valve screens are not clogged. Remove any kinks in hoses. Your hot water tank may not have enough hot water to keep up with the number of hot or warm washes. This is normal. See the "Cycle Guide" for the available settings and options for each cycle. Make sure hot and cold inlet hoses are not reversed. Both hoses must be attached and have water flowing to the inlet valve. Both hot and cold water faucets must be on. Inlet valve screens on washer may be clogged. Remove any kinks in the inlet hose. The suds from non-HE detergent can cause the washer to operate incorrectly. Use only HE detergent. Always measure detergent and follow manufacturer's directions based on load size and soil level. 48