Maytag MMV1175J Installation Instructions - Page 4
Installation Instructions
View all Maytag MMV1175J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION INSTRUCTIONS Remove Mounting Plate Depending on your model, the mounting plate may be in the foam packaging, or it may be attached to the back of the microwave oven. NOTE: To avoid possible damage to the work surface, cover the work surface. 1. Remove any remaining contents from the microwave oven cavity. 2. If the mounting plate is attached to the back of the microwave oven, remove it and set it aside. 3. Tape the microwave oven door closed so that the door does not swing open while the microwave oven is being handled. NOTE: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled. 3. Remove two blower screws attaching blower motor to the microwave oven, and set aside. Rotate Blower Motor The microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip this section if you are using recirculation installation. Keep the damper assembly in case the venting method is changed, or the microwave oven is reinstalled in another location where wall or roof venting may be used. A A. Blower screws (in recessed holes) 4. Disconnect the blower motor wire from the connector. Wall Venting Installation Only A 1. Remove screws attaching damper plate to back of B microwave oven, set the screws aside. A B A. Damper plate B. Screws 2. Turn and hold the damper plate vertically as shown. A A. Blower motor wire B. Connector 5. Lift blower motor out of microwave oven, and set aside. A A. Damper plate A. Blower Motor 4