Maytag MMV5165BAW Installation Instructions - Page 19
Installation, Instructions, ATTACH, THE MOUNTING, PLATE, TO THE WALL, To use toggle, bolts, - handle
View all Maytag MMV5165BAW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation Instructions C2.__A. TTACH THE MOUNTING TO THE WALL (cont.) To use toggle bolts" PLATE Spacing for Toggles More Than Wall Thickness Mounting Plate I Toggle Wings C4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST 1. Remove the back top center blower motor door retaining screw. Blower Back of Belt End 3. Place the mounting plate against the wall and insert the toggle wings into the holes on the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure to coincide bottom line of the Mounting plate with Horizontal line of "Rear wall Template" and then the Mounting plate is properly centered under the cabinet. CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. C3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. Blower Motor Screw 2. Open the blower motor by lifting it up at the back side of the microwave. Remove and save the top and back retaining screws that hold the blower motor in the microwave. Retaining Screw / Retaining Screw 3. Carefully slide the blower motor toward the right, and lift it partially out of the opening. Note: The blower wires are long enough to allow flexible handling while performing these steps. Disconnect the wires if necessary for additional flexibility. • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions TOP CABINET TEMPLATE. on the CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. / 4. Remove the two screws holding the left side inlet sleeve to the blower unit. Snap the inlet sleeve off of the blower. screws Remove_ 19