Maytag MVW8230H Owners Manual 1 - Page 6

3. Remove packing tray from tub Connect Drain Hose 5. Attach drain hose to drain port Remove tape from washer lid, open lid, and remove cardboard packing tray from tub. Remove all other packaging materials from washer tub. Be sure to remove all parts from tray. NOTE: Keep tray in case you need to move washer later. 4. Free power cord Remove the red plastic plug from the black drain port on the back of the washer. If clamp is not already in place on elbow end of drain hose, slide it over end as shown. Squeeze clamp with pliers and slide black elbow end of drain hose onto black drain port and secure with clamp. For a laundry tub or standpipe drain, go to step 6. For a floor drain, remove the preinstalled drain hose form as shown in Step 7. You may need additional parts with separate directions. See the "Tools and Parts" section. 6. Place drain hose in standpipe Drain hose form Firmly grasp power cord plug and pull to free from rear panel. Gently place power cord over console to allow free access to back of washer. 4.5" (114 mm) Place hose into standpipe (shown in picture) or over side of laundry tub. IMPORTANT: 4.5" (114 mm) of drain hose should be inside standpipe; do not force excess hose into standpipe or lay on bottom of laundry tub. Drain hose form must be used. 6