NEC DTP-16HC User Guide - Page 1
NEC DTP-16HC - Dterm Handset Cordless Telephone Manual
UPC - 722580156075
View all NEC DTP-16HC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
3 7 1 4 2 5 6 H andset Buttons and Switches 1. TALK: initiate, disconnect and receive call 2. TRF: transfer a call 3. MUTE: disable the handset transmit * 4. 0 - 9, , #: dial when off-hook 5. CH: change the transmitted channel 6. VOL: 7. change speaker volume when in use (Normal/Medium/High/Loud) change ringer volume when idle (Low/High) Ringer Switch: specify ringer ON/OFF C ordless Handset U ser Guide Dterm, Electra Elite and NEAX are registered trademarks of NEC America, Inc. NEC America, Inc. Corporate Networks Group 1555 W.Walnut Hill Lane, Irving,TX 75038-3796 1-800-TEAM NEC FP0 750204-0 B attery Installation and Operation • Remove battery from box • Charge without interruption for 17.5 hours • Remove cover from back of handset • Plug battery into slot • Be sure clip is facing up • Tuck battery and exposed wires inside • Replace cover firmly • Insert handset into charging slot • LED on base unit turns red during and after charging is complete • Standard nickel-cadmium battery provides 4 hours talk time, 40 hours standby Maintenance • Locate contact point on handset and base unit • Clean with pencil eraser or contact cleaner • Repeat monthly to maintain a good charge Note: After continuous charging, battery can fail to charge/ discharge due to memory effect. This is normal.To correct, operate handset until low battery tone sounds, auto shut-off occurs and the battery fully discharges. Charge battery without interruption for 17.5 hours. If battery still does not charge, replace it. Low Battery • When low in standby mode, LED will blink • When low during handset call, alarm will tone and LED will blink • Full operation may not be available • Set handset onto base unit to recharge Note: Handset will not ring when battery is low. B est Performance Range • Operates in 900Mhz Analog FM Spectrum, with voice scramble • Install multiple base units at least 17 feet apart • Optimum distance between handset and base unit is 30 - 100 feet - without obstructions, depending on environment • RF line provided and recommended for best performance • Handset utilizes 40 separate channels to communicate with base unit - allowing for up to 40 different users within a Base Station Range