NEC LCD4620-2-IT LCD5220/LCD4020-2/LCD4620-2 UM - Page 32

Connecting to a TV* (For U.S.) Initial TV Setup Before watching TV for the first time it is necessary to program the channels. 1. Attach the cable or antenna to the coaxial RF Connector on the side of the monitor. NOTE: Cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National Electric Code (NEC), in particular section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable. 2. Enter the OSD and go to the TUNER menu below. 3. In the TUNING BAND menu select which tuning method (Air, Cable, Cable HRC, Cable IRC) will be used. 4. Enter the CHANNEL SEARCH menu. Press SET to automatically scan and store channels to memory. The channel search will store both analog and digital channels. NOTE: Analog channels are indicated with a -0 following the channel number. Digital channels are indicated with a - followed by a number. For example, channel 2-0 is analog and channel 2-1 is digital. Analog channels may also have separate digital subchannels associated with them. For example channel 3-0 would be analog followed by channel 3-1, 3-2, etc. 5. Once channels are in memory, use the CHANNEL EDIT menu to add or remove channels. Use the CHANNEL LABELS menu to create unique names for channels, if desired. Parental Controls (TV, VIDEO input only) Parents can block certain types of programming based on rating and the content. To block programming: 1. Enter the PARENTAL CONTROL menu, found under the CONFIGURATION submenu within the TUNER OSD. 2. Enter the password. Default password is 0000. This password can be changed in the PASSWORD SET menu. 3. Highlight the square next to the type of programming you wish to block and press SET on the remote. NOTE: Blocking one type of programming will automatically block all higher rated programming also. However, it is possible to unlock this programming while keeping the desired programming blocked. TV TUNER Not all models have the Digital Tuner installed. TUNER TUNING BAND Choose AIR or Cable as TV source. CHECK DTV SIGNAL Shows the status of the Digital TV signal. CHANNEL SEARCH Searches for TV channels and stores them in memory. ADD ON CHANNEL SEARCH Searches for TV channels and stores them in memory without erasing previously stored channels. FINE TUNING Performs fine adjustments to analog channels. CHANNEL EDIT Add or remove channels stored in memory. CHANNEL LABELS Add a label to the channel. CONFIGURATION MENU LANGUAGE TIME ZONE PASSWORD SET Set the Parental Control Password. Factory default password is 0000. PARENTAL CONTROL PARENTAL CONTROL MENU Parents can choose to block types of programming based on rating and content. ADVANCED RATING Downloadable rating, depending on broadcast. Press SET to change setting. CLOSED CAPTION OPTIONS NOTE: Closed captioning settings can not be adjusted for the VIDEO/S-VIDEO inputs. AUTOMATIC is is the only option available for these inputs. RESOLUTION Set the displayed image to the desired resolution. AUDIO AUDIO LANGUAGE Choose the language of audio output. DIGITAL AUDIO OUTPUT Select the digital audio output source. Choose Dolby D/PCM/OFF. * The product you purchased may not have this feature. English-30