NEC LCD4620-2-IT LCD5220/LCD4020-2/LCD4620-2 UM - Page 8
Attaching Mounting Accessories, Installing and removing optional table, top stand
UPC - 805736021950
View all NEC LCD4620-2-IT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Attaching Mounting Accessories The display is designed for use with the VESA mounting system. 1. Attach Mounting Accessories Be careful to avoid tipping monitor when attaching accessories. LCD4020/LCD4620 Using 8 holes 2. Installing and removing optional table top stand CAUTION: Installing and removing the stand must be done by four or more people (LCD5220), by two or more people (LCD4020/LCD4620). To install, follow those instructions included with the stand or mounting apparatus. Use only those devices recommended by the manufacturer. Handle with care when mounting LCD monitor stand and avoid pinching your fingers. Optional table top stand Using 6 holes LCD5220 VESA Mounting Interface Table Protective Sheet NOTE: Place stand onto monitor so that the long end of the feet are in the front. 3. Ventilation Requirements When mounting in an enclosed space or recessed area, leave adequate room between the monitor and the enclosure to allow heat to disperse, as shown below. Figure 1 Mounting accessories can be attached with the monitor in the face down position. To avoid damaging the screen face, place the protective sheet on the table underneath the LCD. The protective sheet was wrapped around the LCD in the original packaging. Make sure there is nothing on the table that can damage the monitor. When using mounting accessories other than NEC compliant and approved, they must comply with the VESAcompatible mounting method. English-6